Recall number R/2004/197

Recall reference

R/2004/197

Recall Type

Car

Recall Date

2004-11-01

Reason for concern

POSSIBILITY THAT THE STEERING WHEEL CAN LOCK WHILST THE VEHICLE IS IN MOTION

Reason for recall

Two scenarios have been identified which may result in the steering column electronic lock (ECL) engaging whilst the vehicle is in motion. (1) The design is such that when the engine is started if the steering column fails to unlock the fuel supply will be shut off if the driver attempts to move the vehicle.However if the voltage at the powertrain control model is low or interrupted fuel shut off may not occur and in consequence the vehicle can be accelerated whilst the steering is locked.(2) During engine cranking the ECL locking pin may not withdraw fully which can result in contact between the lock pin and the locking plate. This can cause noise or ratcheting when the steering is turned. Should the clearance be insufficient the possibility exists that the steering cannot be turned.

Remedy

Recalled vehicles will have the electronic control unit re-programmed and lock mechanism inspected to ascertain whether there is adequate lock plate clearance. Should this not be the case the lock plate will be replaced.

How to check if the vehicle is recalled

Contact the local CADILLAC dealership or manufacturer. You will not need to pay for anything involving the recall.

How the manufacturer will repair

The Recalled vehicles will have the fixing checked and corrected as necessary by and official CADILLAC service.

CADILLAC Reference ID

04006

Number of affected CADILLAC cars

142